小欖鎮(zhèn)防水補漏白蟻防治公司分析刷痕的起因及處理
防水補漏白蟻防治刷痕產(chǎn)生的原因： 
A、涂料本身的原因：主要是涂料的流平性差，涂料的粘渡過高；有觸變性的填料或助劑。
B、施工原因：施工方法錯誤，涂料攪拌后施工時間過長，滾筒表面處理有誤，涂層過薄。
解決的方法：
A、涂料的原因，增加涂料的流杭州防水汕頭興達空調(diào)維修公司188134186-28平性，降低涂料的粘度，盡可能減少有觸變性的填料和助劑，特別要留意墻面涂料的流平劑用在地坪涂料的現(xiàn)象。
B、防水補漏白蟻防治留意施工方法，涂料的熟化時間不要過長。滾筒的二端到圓角，涂層的一遍厚度盡可能不要小于0.15mm。
The causes of brush mark:
A, the cause of the coating itself: mainly poor flowing property of paint, coating glue through high; Packing or thixotropic agent.
B, construction: construction method error, coating construction time is too long, after mixing drum surface treatment is wrong, a thin coating.
Solution: A, coating, increase the coating flow property, lower the viscosity of the coating, minimize the thixotropy of fillers and additives, especially to pay more attention to metope paint flow ping agent used in floor coating. B, pay attention to construction method, coating curing time not too long. The two end of the cylinder to the rounded corners, coating thickness again as far as possible, not less than 0.15 mm.
|
